iDirect Evolution X3 Remote Satellite Modem Router

D22E

iDirect Evolution X3 Remote Satellite Modem Router

NETWORK CONFIGURATION

Network Topology Star (DVB-S2/ACM Outbound + Multi Frequency D-TDMA or SCPC Return*)
Downstream DVB-S2 Upstream TDMA Upstream SCPC Return
Modulation QPSK, 8PSK, 16APSK BPSK, QPSK, 8PSK BPSK, QPSK, 8PSK
FEC LDPC, 1/4 - 8/9 TPC, 0.431 - 0.793**;
2D 16-State, 1/2 - 6/7
2D 16-State, 1/3 - 6/7
Max. Symbol Rate 45 Msps 7.5 Msps 15 Msps
Max. Info Rate 150 Mbps1 12.8 Mbps 24 Mbps
Max. Line Card IP Data Rate 149 Mbps1 11.1 Mbps2
18.2 Mbps3
Max. Remote IP Data Rate 29 Mbps1 7.8 Mbps2
11.8 Mbps31
16APSK 8/9 FEC 2
QPSK 6/7 FEC 3
QPSK 4/5 FEC

INTERFACES

Satcom Interfaces TxIF: Type-F, 950–1700MHz, +7dBm / -35dBm
RxIF: Type-F, 950–2150MHz, -5dBm (max) composite/ -125+10*log(Fsym)dBm (min) single carrier
Software controllable 10 MHz reference on TX Out and RX In ports
BUC IFL Interface +24V, max. 70W, (120W PSU) (please refer to X3 Installation Manual for full list of supported BUCs)
LNB IFL Interface +19V (Nominal), 500mA max
DiSEqC (Voltage 14V/19V + 22KHz tone)
Data Interfaces LAN: 10/100 Ethernet, 802.1q VLAN
RS-232: RJ45 (Console connection)
Protocols Supported TCP, UDP, ACL, ICMP, IGMP, RIP Ver2, Static Routes, NAT, DHCP, DHCP Helper, Local DNS Caching,
cRTP and GRE
Traffic Engineering Group QoS, QoS (Priority Queuing and CBWFQ), Strict Priority Queuing, Application Based QoS, Minimum CIR, CIR
(Static and Dynamic), Rate Limiting
Other Features Built-in Automatic Uplink Power, Frequency and Timing Control, Authentication, Antenna Control Interface
(OpenAMIP)